Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Lubricating Valve Tips

Courtesy of GENERAL MOTORS CORP.

Lubricate the valve tips.

Fig 2: View Of Hydraulic Element Lash Adjusters

Courtesy of GENERAL MOTORS CORP.

Install the hydraulic lash adjusters.

Fig 3: Identifying Exhaust Camshaft Roller Followers

Courtesy of GENERAL MOTORS CORP.

Install the camshaft roller followers.

Fig 4: View Of Camshaft Alignment Notches

Courtesy of GENERAL MOTORS CORP.

Ensure that the alignment notches are aligned with the camshaft sprocket.

Fig 5: View Of Camshaft & Bearing Caps

Courtesy of GENERAL MOTORS CORP.

Install the exhaust camshaft.
Install the camshaft caps.

NOTE: Refer to Fastener Notice .

Tighten the camshaft cap bolts in increments of 3 turns until they are seated.
Tighten: Tighten the camshaft cap bolts to 10 N.m (89 lb in).
Install camshaft sprockets onto the camshafts.
Hand tighten NEW camshaft sprocket bolts.
Remove the J 43655 . See Special Tools .

Fig 6: Holding Camshaft Stationary With Wrench On Hex Casting On Camshaft

Courtesy of GENERAL MOTORS CORP.

Tighten the camshaft sprocket bolts.
Tighten: Tighten the bolts to 85 N.m (63 lb ft) plus 30 degrees.

Fig 7: View Of Upper Timing Chain Guide

Courtesy of GENERAL MOTORS CORP.

Install the upper timing chain guide.
Tighten: Tighten the upper timing chain guide to 10 N.m (89 lb in).
Install the camshaft cover. Refer to Camshaft Cover Replacement .
Install the CMP sensor. Refer to Camshaft Position Sensor Replacement .