LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 677 (Engine Mechanical - 2.0L (LSJ)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Oil Cooler Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Oil Cooler
    GM1577505Courtesy of GENERAL MOTORS CORP.
  1. Install the oil cooler.
    2. NOTE: Refer to Fastener Notice .
  2. Install the oil cooler bolts (4) and stud (3).

    Tighten:  Tighten the bolts and stud to 22 N.m (16 lb ft).

  3. Connect the oil cooler hoses (2).
  4. Install the oil pressure sensor (1).

    Tighten:  Tighten the sensor to 22 N.m (16 lb ft).

  5. Fill the charged air cooling system. Refer to Draining and Filling Cooling System - Charge Air Cooling System .
scientia non olet · About LEMON Manuals