LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 677 (Engine Mechanical - 2.0L (LSJ)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Intermediate Bracket
    GM851554Courtesy of GENERAL MOTORS CORP.
  1. Install the intermediate bracket to the engine.
  2. Hand tighten the engine mount intermediate bracket bolts in the following locations:
    • The long bolts in the forward and front lower holes
    • The short bolt in the rear upper hole
    3. NOTE: Refer to Fastener Notice .
  3. Tighten the intermediate bracket bolts.

    Tighten:  Tighten the bolts to 100 N.m (74 lb ft).

  4. Install the engine mount. Refer to Engine Mount Replacement .
scientia non olet · About LEMON Manuals