LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 677 (Engine Mechanical - 2.0L (LSJ)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Drive Belt (Removed)
    GM1600754Courtesy of GENERAL MOTORS CORP.
  1. From through the wheel house opening, install the drive belt.
  2. Route the drive belt around the A/C compressor and crankshaft balancer and under the idler pulley.
  3. Install the right front fender liner. Refer to Front Fender Liner Replacement .
  4. Route the drive belt around the supercharger and generator pulleys.
  5. Ensure that the drive belt is still properly seated in the pulley grooves.
    6. Fig 2: View Of Drive Belt Tensioner
    GM1676788Courtesy of GENERAL MOTORS CORP.
  6. Very slowly push down and towards the back of the vehicle in order to slowly compress the drive belt tensioner.
  7. Install the drive belt over the drive belt tensioner.
  8. Very slowly, allow the drive belt tensioner to return to the extended position until tension is applied to the drive belt.
    9. Fig 3: View Of Drive Belt (Installed)
    GM1676786Courtesy of GENERAL MOTORS CORP.
  9. Remove the 15 mm open end wrench from the drive belt tensioner lug on the rear of the tensioner.
scientia non olet · About LEMON Manuals