LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 677 (Engine Mechanical - 2.0L (LSJ)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Balancer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Crankshaft Balancer
    GM412138Courtesy of GENERAL MOTORS CORP.
  1. Install the crankshaft balancer.
  2. Install a NEW crankshaft balancer bolt.
    3. Fig 2: View Of Harmonic Balancer Holder J38122-A
    GM467429Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Use J 38122-A  to prevent the crankshaft from rotating while tightening the crankshaft balancer bolt. See Special Tools .

    Tighten:  Tighten the bolt to 100 N.m (74 lb ft) plus 75 degrees.

  4. Install the engine drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals