LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 677 (Engine Mechanical - 2.0L (LSJ)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Intake Manifold Installation

Intake Manifold Installation

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Intake Manifold Studs
    GM412542Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the intake manifold studs in the manifold face.

    Tighten:  Tighten the intake manifold studs to 5 N.m (44 lb in).

    2. Fig 2: View Of Intake Manifold
    GM1339178Courtesy of GENERAL MOTORS CORP.
  2. Install a new intake manifold gasket on the intake manifold.
  3. Install the intake manifold.
  4. Install the intake manifold bolts and nuts.

    Tighten:  Tighten the bolts and nuts to 22 N.m (16 lb ft).

scientia non olet · About LEMON Manuals