LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 677 (Engine Mechanical - 2.0L (LSJ)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Exhaust Manifold Removal

Exhaust Manifold Removal

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Exhaust Manifold Heat Shield
    GM1381505Courtesy of GENERAL MOTORS CORP.
  1. Remove the exhaust manifold heat shield.
    2. Fig 2: View Of Oxygen Sensor
    GM1381506Courtesy of GENERAL MOTORS CORP.
  2. Remove the oxygen sensor.
    3. Fig 3: View Of Exhaust Manifold
    GM1398727Courtesy of GENERAL MOTORS CORP.
  3. Remove and discard the exhaust manifold to cylinder head retaining nuts.
  4. Remove the exhaust manifold.
  5. Clean all of the sealing surfaces.
  6. If the exhaust manifold is being replaced, transfer the following parts:
    • The exhaust manifold heat shield
    • The oxygen sensor
scientia non olet · About LEMON Manuals