Engine Flywheel Installation

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 45059 Angle Meter. See Special Tools .
J 38122-A Crankshaft Balancer Holder

Fig 1: Identifying Flywheel & Retaining Bolts

Courtesy of GENERAL MOTORS CORP.

Install the flywheel.
Install the new bolts.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Holding the crankshaft balancer with the J 38122-A , tighten the bolts evenly.
Tighten: Using the J 45059 , tighten the bolts to 53 N. See Special Tools .m (39 lb ft), plus 25 degrees.