Camshaft Cover Installation

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Camshaft Cover Assembly

Courtesy of GENERAL MOTORS CORP.

Assemble the camshaft cover and gasket. Ensure that the gasket is located in the retaining groove in the camshaft cover.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the cover on the cylinder head and hand start the bolts.
Tighten: Tighten the camshaft cover bolts to 8 N.m (71 lb in).

Fig 2: Identifying Spark Plugs

Courtesy of GENERAL MOTORS CORP.

Install the spark plugs.
Tighten: Tighten the spark plugs to 20 N.m (15 lb ft).

Fig 3: Identifying Ignition Coil

Courtesy of GENERAL MOTORS CORP.

Install the ignition coil and module assembly bolts to the cam cover.
Install the ignition coil and module assembly bolts.
Tighten: Tighten the ignition coil and module assembly bolts to 8 N.m (71 lb in).

Fig 4: View Of Ignition Coil Cover

Courtesy of GENERAL MOTORS CORP.

Install the ignition coil cover.
Install the ignition coil cover bolts.
Tighten: Tighten the bolts to 8 N.m (71 lb in).

Fig 5: View Of Lift Hook

Courtesy of GENERAL MOTORS CORP.

Install the lift hook.
Install the lift hook bolts.
Tighten: Tighten the bolts to 22 N.m (16 lb ft).

Fig 6: View Of Camshaft Position Sensor

Courtesy of GENERAL MOTORS CORP.

Install the camshaft position sensor.
Install the camshaft position sensor bolt.
Tighten: Tighten the bolt to 8 N.m (71 lb in).

Fig 7: View Of Power Steering Blockout Plate

Courtesy of GENERAL MOTORS CORP.

Install the power steering blockout plate.
Install the power steering blockout plate studs.
Tighten: Tighten the power steering blockout plate bolts to 25 N.m (18 lb ft).