LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 673 (Drum Brake System) >> Repair Instructions >> Drum Brake Hardware Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (4 Lug Wheel) or Tire and Wheel Removal and Installation (5 Lug Wheel) .
  3. Remove the brake drum. Refer to Brake Drum Replacement .
    4. Fig 1: Pulling Universal Spring End Out Of Shoe Web Hole
    GM890726Courtesy of GENERAL MOTORS CORP.
  4. Position the hook end of the J 38400  (1) under the universal spring and lightly pull the universal spring end out of the shoe web hole. See Special Tools .
    5. Fig 2: Using J 38400 To Pull Universal Spring
    GM900069Courtesy of GENERAL MOTORS CORP.
  5. Position the hook end of the J 38400  (1) under the universal spring and lightly pull the universal spring end out of the shoe web hole. See Special Tools .
    6. Fig 3: View Of Brake Drum Universal Spring
    GM891442Courtesy of GENERAL MOTORS CORP.
  6. Remove the universal spring (1) from the brake backing plate.
scientia non olet · About LEMON Manuals