LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 673 (Drum Brake System) >> Repair Instructions >> Drum Brake Hardware Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Brake Drum Universal Spring
    GM891442Courtesy of GENERAL MOTORS CORP.
  1. Install the universal spring (1) to the brake backing plate.
    2. Fig 2: Using J 38400 To Pull Universal Spring
    GM900069Courtesy of GENERAL MOTORS CORP.
  2. Position the hook end of the J 38400  (1) under the universal spring and lightly pull the universal spring end out, away from the hub, while installing the spring end into the shoe web hole. See Special Tools .
    3. Fig 3: Pulling Universal Spring End Out Of Shoe Web Hole
    GM890726Courtesy of GENERAL MOTORS CORP.
  3. Position the hook end of the J 38400  (1) under the universal spring and lightly pull the universal spring end out, away from the hub, while installing the spring end into the shoe web hole. See Special Tools .
  4. Install the brake drum. Refer to Brake Drum Replacement .
  5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (4 Lug Wheel) or Tire and Wheel Removal and Installation (5 Lug Wheel) .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals