LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 672 (Parking Brake System) >> Repair Instructions >> Park Brake Lever Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Park Brake Lever Assembly
    GM1395429Courtesy of GENERAL MOTORS CORP.
  1. Install the park brake lever assembly to the vehicle.
    2. NOTE: Refer to Fastener Notice .
    IMPORTANT: Tighten the park brake lever assembly mounting nuts in the sequence shown.
  2. Install the park brake lever assembly mounting nuts.

    Tighten:  Tighten the nuts in sequence to 25 N.m (18 lb ft).

    3. Fig 2: View Of Park Brake Lever Bracket, Rear Cable Fittings, & Rear Cable Ends
    GM1395425Courtesy of GENERAL MOTORS CORP.
  3. Secure the rear cable fittings (2) to the park brake lever bracket (1). Attempt to pull the park brake cables free of the lever bracket, to ensure that the retaining tabs on the fittings are properly secured.
  4. Install the cable ends (3) to the cable equalizer.
    5. Fig 3: Locating Park Brake Warning Lamp Switch Electrical Connector
    GM891320Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connector (1) to the park brake warning lamp switch.
  6. Adjust the park brake cable tension. Refer to Park Brake Adjustment (Disc)  or Park Brake Adjustment (Drum) .
  7. Install the front floor console. Refer to Front Floor Console Replacement .
  8. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals