LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 669 (Rear Suspension System) >> Repair Instructions >> Wheel Bearing/Hub Replacement - Rear (Drum Brake) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (4 Lug Wheel) or Tire and Wheel Removal and Installation (5 Lug Wheel) .
  3. Remove the brake drum. Refer to Brake Drum Replacement .
    4. Fig 1: Rear View Of Wheel Bearing/Hub Assembly
    GM890721Courtesy of GENERAL MOTORS CORP.
  4. Remove the plug from the drum brake actuator access hole in the backing plate. Using the access hole, install a support (1) for the brake backing plate.
  5. Disconnect the electrical connector (2) from the wheel speed sensor, if equipped with ABS.
  6. Remove the wheel bearing/hub assembly mounting nuts (3).
    7. Fig 2: View Of Wheel Bearing/Hub Assembly - Drum Brake
    GM890719Courtesy of GENERAL MOTORS CORP.
  7. Remove the wheel bearing/hub assembly from the rear axle assembly and brake backing plate.
scientia non olet · About LEMON Manuals