LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 669 (Rear Suspension System) >> Repair Instructions >> Coil Spring Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Support the rear axle with tall jack stands near each rear shock absorber.
  3. Remove the U-clips from the rear brake hose brackets at the rear axle.
  4. Remove the lower shock bolts. Refer to Shock Absorber Replacement .
  5. Using the tall jack stands, slowly lower the rear axle in order to remove tension from the rear springs.
    6. Fig 1: View Of Coil Spring
    GM855051Courtesy of GENERAL MOTORS CORP.
  6. Remove the spring.
    7. Fig 2: View Of Upper Spring Seat/Jounce Bumper
    GM855055Courtesy of GENERAL MOTORS CORP.
  7. Remove the upper spring seat/jounce bumper from the spring, while leaving the lower spring seat on the axle.
scientia non olet · About LEMON Manuals