Conditions for Clearing the DTC

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

A current DTC clears when the malfunction is no longer present.
A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction.

DTC B1001

Step	Action	Yes	No
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to DIAGNOSTIC SYSTEM CHECK - VEHICLE
2	Install a scan tool. Turn ON the ignition, with the engine OFF. Perform the Restraints ID Relearn procedure. Refer to Body Control Module Programming and Setup . Cycle the ignition. Retrieve DTCs from the body control module (BCM). Is DTC retrieved as a current DTC?	Go to Step 3	Go to Step 4
3	IMPORTANT: Perform the setup procedure for the BCM. Replace the BCM. Refer to Body Control Module Replacement .Did you complete the replacement?	Go to Step 4	-
4	Use the scan tool in order to clear the DTCs. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text. Does the DTC reset?	Go to Step 1	System OK