LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 664 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Underhood Electrical Center or Junction Block Bracket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the cover (2) from the underhood electrical center.
    3. Fig 1: Underhood Electrical Center
    GM1548078Courtesy of GENERAL MOTORS CORP.
  3. Remove the underhood positive battery terminal lug (4).
    4. IMPORTANT: Take note of the positioning of the positive battery cables before disconnecting the cables.
  4. Disconnect the positive battery cables (5) from the underhood electrical center.
    5. IMPORTANT: The underhood electrical center bolts (3) are retained in the electrical center.
  5. Loosen all of the underhood electrical center bolts (3).
  6. Remove the underhood electrical center (1) from the vehicle.
scientia non olet · About LEMON Manuals