LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 664 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition and Start Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  2. Disconnect the ignition switch harness connector.
  3. Turn the ignition switch to the run position.
    4. Fig 1: View Of Ignition Switch
    GM854768Courtesy of GENERAL MOTORS CORP.
  4. Remove the ignition switch screws.
    5. IMPORTANT: The ignition switch must be in the run position during removal in order to avoid damage to the ignition switch.
  5. Remove the ignition switch from the steering column.
scientia non olet · About LEMON Manuals