LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 664 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition Lock Cylinder Solenoid Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
    2. Fig 1: View Of Ignition Switch Harness Connector
    GM854934Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the ignition lock cylinder solenoid harness connector.
    3. Fig 2: View Of Ignition Lock Cylinder Solenoid
    GM854930Courtesy of GENERAL MOTORS CORP.
  3. Remove the ignition lock cylinder solenoid screws.
    4. IMPORTANT: Do not attempt to remove any roll pins retaining the plunger mechanism. The ignition lock cylinder solenoid replacement part consists of only the solenoid and spring. If the plunger mechanism exhibits any signs of damage or wear then replacement of the ignition lock cylinder case will be necessary.
  4. Remove the ignition lock cylinder solenoid from the lock cylinder case housing.
scientia non olet · About LEMON Manuals