LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 664 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition Lock Cylinder Solenoid Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Clean the solenoid and plunger with a lint free cloth prior to installation. Oil or debris may cause ignition lock cylinder solenoid malfunction.
  1. Install a new spring over the ignition lock cylinder solenoid plunger.
  2. Carefully install the new ignition lock cylinder solenoid over the plunger.
    3. Fig 1: View Of Ignition Lock Cylinder Solenoid
    GM854930Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Seat the ignition lock cylinder solenoid on the lock cylinder case housing and install the screws.

    Tighten:  Tighten the screws to 2 N.m (17 lb in).

    4. Fig 2: View Of Ignition Switch Harness Connector
    GM854934Courtesy of GENERAL MOTORS CORP.
  4. Connect the lock cylinder solenoid harness connector.
  5. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  6. Check the operation of the ignition lock cylinder solenoid.
scientia non olet · About LEMON Manuals