LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 664 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition Lock Cylinder Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Turning Ignition Lock Cylinder To RUN Position
    GM874786Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: If you are installing a new lock cylinder, refer to Key and Lock Cylinder Coding .
  1. Position the lock cylinder in the run position. Insert the cylinder into the lock housing.
  2. Rotate the lock cylinder in the housing. Verify proper rotation.
  3. Install the theft deterrent control module, if equipped. Refer to Theft Deterrent Module Replacement .
  4. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  5. Enable the SIR system. Refer to SIR Disabling and Enabling .
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  7. Program the theft deterrent control module, if equipped. Refer to Control Module References .
scientia non olet · About LEMON Manuals