Installation Procedure
WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Position the horn (2) into the slot in the front frame rail.
- Install the horn bracket bolt (1).
Tighten: Tighten the bolt to 10 N.m (89 lb in).
- Connect the horn electrical connector.
- Install the left headlamp housing bracket. Refer to HEADLAMP REPLACEMENT .
NOTE:
Refer to Fastener Notice
.