LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 661 (Wiper System & Washer System) >> Repair Instructions >> Wiper Motor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wiper Motor
    GM1235608Courtesy of GENERAL MOTORS CORP.
  1. Position the wiper motor to the wiper drive system module.
    2. NOTE: Refer to Fastener Notice .
  2. Install the wiper motor screws.

    Tighten:  Tighten the screws to 8 N.m (71 lb in).

  3. Install the wiper motor crank arm and crank arm nut.

    Tighten:  Tighten the screws to 25 N.m (18 lb ft).

  4. Install the wiper drive system module. Refer to Wiper Drive System Module Replacement .
  5. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
scientia non olet · About LEMON Manuals