LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 661 (Wiper System & Washer System) >> Repair Instructions >> Washer Solvent Container Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Washer Solvent Container
    GM869670Courtesy of GENERAL MOTORS CORP.
  1. Position the washer solvent container to the right frame rail.
    2. NOTE: Refer to Fastener Notice .
  2. Install the washer solvent container screws.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

  3. Connect the washer pump and level sensor switch electrical connectors.
  4. Connect the washer pump hose to the washer pump spout.
  5. Install the front fender liner. Refer to Front Fender Liner Replacement .
  6. Fill the washer solvent container with new washer solvent.
  7. Verify the washer pump operation and inspect for leaks.
scientia non olet · About LEMON Manuals