Installation Procedure
WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Install the mode actuator assembly.
- Install the mode actuator assembly screws.
Tighten: Tighten the screws to 2.2 N.m (19 lb in).
- Install the mode actuator electrical connector.
- Install the air temperature actuator. Refer to Air Temperature Actuator Replacement .
- Start the engine and let run for one minute.
IMPORTANT:
The key should be in the OFF position when connecting the electrical connectors to ensure proper calibration.
NOTE:
Refer to Fastener Notice
.
IMPORTANT:
Do not adjust any controls on the HVAC control assembly while the HVAC control assembly and actuators are calibrating. If interrupted improper HVAC performance will result.