LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 654 (Power Steering System) >> Diagnostic Information and Procedures >> DTC C0545 >> Diagnostic Aids

Diagnostic Aids

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

DTC C0545 4B will set upon the first ignition ON cycle after PSCM replacement.

DTC C0545

Step Action Yes No
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to DIAGNOSTIC SYSTEM CHECK - VEHICLE
2
  1. Turn ON the ignition, with the engine OFF.
  2. With a scan tool, observe the DTC Information for DTC C0545 00.
Does the scan tool indicate that DTC C0545 4B is current?		 Go to Step 3  Go to Step 4 
3 Calibrate the torque sensor. Refer to Control Module References .
Did you complete the repair?		 Go to Step 4  -
4
  1. Clear the DTCs with the scan tool.
  2. Operate the vehicle within the Conditions for Running the DTC.
Does the DTC reset?		 Go to Step 2  System OK
scientia non olet · About LEMON Manuals