LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 653 (Front Suspension System) >> Repair Instructions >> Wheel Stud Replacement (5-Stud Pattern) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Wheel Stud Using Washers & Wheel Nut - 5-Stud Pattern
    GM1233071Courtesy of GENERAL MOTORS CORP.
  1. With the bearing hub still in position, install the NEW stud into the bearing/hub assembly.
  2. Add enough washers (1) in order to draw the stud into the hub.
  3. Install the wheel nut (2) with the flat side against the washers.
  4. Tighten the wheel nut until the head of the wheel stud is fully seated against the back of the bearing hub flange.
  5. Remove the wheel nut and the washers.
  6. Install the brake rotor, and install the brake caliper and bracket as an assembly. Refer to Front Brake Rotor Replacement .
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (4 Lug Wheel) or Tire and Wheel Removal and Installation (5 Lug Wheel) .
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals