LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 653 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement (FE1/FE3) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the front wheels. Refer to Tire and Wheel Removal and Installation (4 Lug Wheel) or Tire and Wheel Removal and Installation (5 Lug Wheel) .
  3. Remove the rear transaxle mount. Refer to Transmission Rear Mount Replacement for the Getrag 5 Speed transmission, or Transmission Rear Mount Replacement for the MU3 transmission, or Transmission Rear Mount Replacement for the 4T40-E/4T45-E transaxle.
  4. Remove the steering gear. Refer to Power Steering Gear Replacement .
  5. Disconnect the stabilizer links from the stabilizer shaft. Refer to Stabilizer Shaft Link Replacement .
    6. Fig 1: View Of Stabilizer Bar Mounting Clamp
    GM851715Courtesy of GENERAL MOTORS CORP.
  6. Remove the stabilizer bar mounting clamp bolts and clamps from both sides of the vehicle.
    7. Fig 2: View Of Stabilizer Bar
    GM851718Courtesy of GENERAL MOTORS CORP.
  7. Remove the bushings from the stabilizer bar.
  8. Lift and rotate the stabilizer bar up and to the right.
  9. Carefully remove the stabilizer bar from the right side of the vehicle.
scientia non olet · About LEMON Manuals