Stabilizer Shaft Insulator Replacement (FE5)
WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Stabilizer Shaft Insulator Replacement (FE5)
| Callout | Component Name |
|---|---|
|
NOTE:
Refer to Fastener Notice
. Fastener Tightening Specifications:
Refer to Fastener Tightening Specifications .Preliminary Procedure: Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
. |
|
| 1 | Front Stabilizer Shaft Clamp Bolt Tighten: 50 N.m (37 lb ft) |
| 2 | Front Stabilizer Shaft Clamp Nut Tighten: 50 N.m (37 lb ft) |
| 3 | Front Stabilizer Shaft Clamp |
| 4 | Front Stabilizer Shaft Insulator Tip: Place the cut line of the insulator facing the rear of the vehicle. |