LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 653 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement (FE1/FE3) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Stabilizer Bar
    GM851718Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer bushings on the stabilizer shaft with the cut line facing rearward.
    2. Fig 2: View Of Stabilizer Bar Mounting Clamp
    GM851715Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the stabilizer shaft clamps and bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  3. Install the front wheels. Refer to Tire and Wheel Removal and Installation (4 Lug Wheel) or Tire and Wheel Removal and Installation (5 Lug Wheel) .
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals