LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 652 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Intake Manifold Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. If applicable, install the intake manifold gasket.
  2. Install the intake manifold.
    3. Fig 1: View Of Intake Manifold
    GM412135Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the intake manifold nuts and bolts.

    Tighten:  Tighten the intake manifold nuts and bolts to 10 N.m (89 lb in).

    4. Fig 2: View Of Knock Sensor Connector
    GM630348Courtesy of GENERAL MOTORS CORP.
  4. Install the knock sensor harness connector to the intake manifold.
  5. Connect the knock sensor electrical connector.
  6. Install the fuel rail. Refer to Fuel Rail Assembly Replacement .
  7. Install the throttle body.
  8. Install the oil level indicator tube bolt.

    Tighten:  Tighten the oil level indicator tube bolt to 10 N.m (89 lb in).

  9. Connect the brake booster hose.
  10. Connect the purge solenoid tube.
  11. Connect the PCV hose.
  12. Install the throttle body. Refer to Throttle Body Assembly Replacement .
  13. Install the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
scientia non olet · About LEMON Manuals