LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 652 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Mount
    GM851555Courtesy of GENERAL MOTORS CORP.
  1. Place the engine mount onto the midrail and hand start the nuts.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Tighten the engine mount to midrail nuts.

    Tighten:  Tighten the nuts to 100 N.m (74 lb ft).

    3. Fig 2: View Of Engine Mount To Intermediate Bracket Bolts
    GM851553Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The engine mount to intermediate bracket bolts must be hand started. Do not pry the engine mount to align the holes.
  3. Hand start the engine mount to intermediate bracket bolts.
  4. Tighten the engine mount to intermediate bracket bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  5. Remove the hydraulic floor jack.
  6. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
scientia non olet · About LEMON Manuals