LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 652 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Replacement - Right Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Torque axis mounting systems allow more engine movement than other mounting systems. The engine movement is the design intent of the mounting system. Do not replace the torque axis mounts unless the mount or the rubber is damaged.
    Fig 1: View Of A/C Low Pressure Line Retaining Bracket
    GM794327Courtesy of GENERAL MOTORS CORP.
  1. Remove the A/C low pressure line retaining bracket (1) nut. Refer to Compressor Hose Assembly Replacement (RPOs L61, LE5) .
    2. Fig 2: Aligning Floor Jack & Oil Pan
    GM789908Courtesy of GENERAL MOTORS CORP.
  2. Using a block of wood between the floor jack and the oil pan, support the engine.
    3. Fig 3: View Of Engine Mount To Bracket Bolts
    GM794303Courtesy of GENERAL MOTORS CORP.
  3. Remove the engine mount (2) to bracket bolts (1).
    4. Fig 4: View Of Engine Mount To Body Nuts
    GM794701Courtesy of GENERAL MOTORS CORP.
  4. Remove the engine mount to body nuts (1).
  5. Remove the engine mount.
scientia non olet · About LEMON Manuals