Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Install the engine mount to the vehicle.

Fig 1: Aligning Engine Mount

Courtesy of GENERAL MOTORS CORP.

Align the engine mount (2) to the mount bracket using a dowel (1).

Fig 2: View Of Engine Mount To Body Nuts

Courtesy of GENERAL MOTORS CORP.

Hand tighten the engine mount to body nuts (1).

Fig 3: View Of Engine Mount To Bracket Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the engine mount (2) to bracket bolts (1).
Tighten:
- Tighten the engine mount to body nuts to 66 N.m (49 lb ft).
- Tighten the engine mount to bracket bolts to 130 N.m (96 lb ft) plus 45 degrees.

Fig 4: View Of A/C Low Pressure Line Retaining Bracket

Courtesy of GENERAL MOTORS CORP.

Install the A/C low pressure line retaining bracket (1) nut. Refer to Compressor Hose Assembly Replacement (RPOs L61, LE5) .
Tighten: Tighten the nut to 10 N.m (89 lb in).
Remove the floor jack.