LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 652 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Drive Belt
    GM1571093Courtesy of GENERAL MOTORS CORP.
  1. Install and position the drive belt around all of the pulleys except for the drive belt tensioner.
  2. Install the J 44811  to the drive belt tensioner.
  3. Using the J 44811  , rotate the tensioner counterclockwise.
  4. Position the drive belt under the tensioner pulley.
    5. Fig 2: View Of Drive Belt Tensioner And Special Tool
    GM854300Courtesy of GENERAL MOTORS CORP.
  5. Using the J 44811  , rotate the tensioner clockwise in order to seat the tensioner pulley onto the drive belt.
  6. Install the engine splash shield. Refer to Splash Shield Replacement - Engine .
scientia non olet · About LEMON Manuals