LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 652 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Camshaft Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying camshaft cover bolts
    GM1751021Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the camshaft cover and bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    2. Fig 2: View of engine wiring harness clip
    GM1752846Courtesy of GENERAL MOTORS CORP.
  2. Install the engine wiring harness clip to the camshaft cover.
    3. Fig 3: View of engine wiring harness clips
    GM1751022Courtesy of GENERAL MOTORS CORP.
  3. Install the engine wiring harness clips (1 and 4) to the stud (2) and camshaft cover (3).
    4. Fig 4: View of ground strap
    GM1752914Courtesy of GENERAL MOTORS CORP.
  4. Install the ground strap (4) to the camshaft cover.
  5. Install the ground strap stud (3) to the camshaft cover.

    Tighten:  Tighten the stud to 10 N.m (89 lb in).

  6. Install the fuel pipe bracket (2) to the ground strap stud.
  7. Install the fuel pipe bracket nut (1).

    Tighten:  Tighten the nut to 10 N.m (89 lb in).

  8. Install the ignition coils. Refer to Ignition Coil Replacement .
  9. Install the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
  10. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals