Engine Flywheel Installation

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 38122-A Crankshaft Balancer Holder
J 45059 Angle Meter

Fig 1: View Of Flywheel

Courtesy of GENERAL MOTORS CORP.

Install the flywheel.
Install the NEW bolts.

NOTE: Refer to FASTENER NOTICE .

Holding the crankshaft balancer with the J 38122-A , tighten the bolts evenly.
Tighten: Tighten the bolts to 53 N.m (39 lb ft), plus 25 degrees using the J 45059 .