LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 651 (Battery, Charging System And Starting System) >> Repair Instructions >> Starter Motor Replacement (RPO LSJ) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Negative Battery Cable
    GM1656132Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the charge air cooler pump. Refer to Coolant Pump Replacement - Charge Air Cooler .
  4. Remove the starter solenoid terminal nut (6).
  5. Remove the positive battery cable terminal (5) and the starter solenoid terminal (4) from the starter.
    6. Fig 2: View Of Starter Solenoid
    GM1656247Courtesy of GENERAL MOTORS CORP.
  6. Remove the starter solenoid "S" terminal nut (1).
  7. Remove the engine harness terminal (2) from the starter.
    8. Fig 3: Identifying Starter Bolts & Starter
    GM1648192Courtesy of GENERAL MOTORS CORP.
  8. Remove the starter bolts.
  9. Remove the starter.
scientia non olet · About LEMON Manuals