LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 651 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Replacement (RPOs L61/LE5) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Engine Harness Electrical Connector
    GM1647528Courtesy of GENERAL MOTORS CORP.
  1. Disconnect negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the drive belt. Refer to Drive Belt Replacement or Drive Belt Replacement .
  3. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Resonator Replacement or Air Cleaner Outlet Duct Replacement .
  4. Disconnect the engine harness electrical connector (3) from the generator.
    5. Fig 2: View Of Starter Solenoid Wire Terminal And Generator
    GM1656132Courtesy of GENERAL MOTORS CORP.
  5. Reposition the starter solenoid wire boot (3).
  6. Remove the generator terminal nut (2).
  7. Remove the starter solenoid wire terminal (1) from the generator.
    8. Fig 3: View Of Generator
    GM1650517Courtesy of GENERAL MOTORS CORP.
  8. Remove the generator bolts.
  9. Remove the generator.
scientia non olet · About LEMON Manuals