LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 651 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Replacement (RPOs L61/LE5) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Generator To Engine Block
    GM1650517Courtesy of GENERAL MOTORS CORP.
  1. Position the generator to the engine block.
    2. NOTE: Refer to Fastener Notice .
  2. Install the generator bolts.

    Tighten:  Tighten the bolts to 22 N.m (16 lb ft).

    3. Fig 2: View Of Starter Solenoid Wire Terminal To Generator
    GM1656132Courtesy of GENERAL MOTORS CORP.
  3. Install the starter solenoid wire terminal (1) to the generator.
  4. Install the generator terminal nut (2).

    Tighten:  Tighten the nut to 20 N.m (15 lb ft).

  5. Position the starter solenoid wire boot (3).
    6. Fig 3: Identifying Engine Harness Electrical Connectors
    GM1647528Courtesy of GENERAL MOTORS CORP.
  6. Connect the engine harness electrical connector (3) to the generator.
  7. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Resonator Replacement or Air Cleaner Outlet Duct Replacement .
  8. Install the drive belt. Refer to Drive Belt Replacement or Drive Belt Replacement .
  9. Connect negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals