LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 651 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Replacement (RPO LSJ) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Engine Harness Electrical Connector
    GM1650527Courtesy of GENERAL MOTORS CORP.
  1. Disconnect negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the supercharger. Refer to Supercharger Replacement .
  3. Reposition the starter solenoid wire boot (3).
  4. Remove the generator harness nut (2).
  5. Remove the starter solenoid wire terminal (1) from the generator.
  6. Disconnect the engine harness electrical connector (4) from the generator.
    7. Fig 2: View Of Generator
    GM1381708Courtesy of GENERAL MOTORS CORP.
  7. Remove the generator bolts.
  8. Remove the generator.
scientia non olet · About LEMON Manuals