Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Negative Battery Cable

Courtesy of GENERAL MOTORS CORP.

Install the positive battery cable (1) to the conduit.

Fig 2: Wrapping Tape Around Positive/Negative Battery Cable Conduit

Courtesy of GENERAL MOTORS CORP.

Wrap tape around the positive/negative battery cable conduit (1).

Fig 3: View Of Positive Battery Cable Terminal To Starter Solenoid (RPO LSJ)

Courtesy of GENERAL MOTORS CORP.

If equipped with RPO LSJ, perform the following steps, install the positive battery cable terminal (2) to the starter solenoid.

NOTE: Refer to Fastener Notice .

Install the starter solenoid terminal nut (3).
Tighten: Tighten the nut to 17 N.m (13 lb ft).

Fig 4: View Of Positive Battery Cable Terminal To Starter Solenoid (RPOs L61 or LE5)

Courtesy of GENERAL MOTORS CORP.

If equipped with RPOs L61 or LE5, perform the following steps, Install the positive battery cable terminal (3) to the starter solenoid.
Install the starter solenoid terminal nut (4).
Tighten: Tighten the nut to 17 N.m (13 lb ft).
Lower the vehicle.

Fig 5: View Of Positive Battery Cable Terminal To Junction Block Stud

Courtesy of GENERAL MOTORS CORP.

Install the positive battery cable terminal (2) to the junction block stud.
Install the junction block nut (1).
Tighten: Tighten the nut to 17 N.m (13 lb ft).
Install the positive battery cable clip (3) to the ECM bracket.
Install the junction block cover.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .