LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 651 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Negative Cable Replacement (Engine to Chassis) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Negative Battery Cable
    GM1656338Courtesy of GENERAL MOTORS CORP.
  1. Install the negative battery cable (2) to the conduit.
    2. Fig 2: Wrapping Tape Around Positive/Negative Battery Cable Conduit
    GM1656337Courtesy of GENERAL MOTORS CORP.
  2. Wrap tape around the positive/negative battery cable conduit (1).
    3. Fig 3: View Of Negative Battery Cable Ground Terminal And Stud
    GM1656239Courtesy of GENERAL MOTORS CORP.
  3. Install the negative battery cable ground terminal to the stud.
    4. NOTE: Refer to Fastener Notice .
  4. Install the battery cable ground nut to the stud on the side rail.

    Tighten:  Tighten the nut to 20 N.m (15 lb ft).

    5. Fig 4: Positioning Negative Battery Cable Ground Terminal To Engine Block (RPO LSJ)
    GM1656341Courtesy of GENERAL MOTORS CORP.
  5. If equipped with RPO LSJ perform the following, position the negative battery cable ground terminal (5) to the engine block.
  6. Position the engine harness ground (4) on top of the ground terminal.
  7. Install the stud (2).

    Tighten:  Tighten the stud to 25 N.m (18 lb ft).

  8. Install the engine harness grounds (2) onto the stud.
  9. Install the engine harness ground nut (1).

    Tighten:  Tighten the nut to 17 N.m (13 lb ft).

    10. Fig 5: Positioning Negative Battery Cable Ground Terminal To Engine Block (RPOs L61/LE5)
    GM1656340Courtesy of GENERAL MOTORS CORP.
  10. If equipped with RPOs L61/LE5 with M86 perform the following, position the negative battery cable ground terminal (4) to the engine block.
  11. Install the stud (2).

    Tighten:  Tighten the stud to 25 N.m (18 lb ft).

  12. Install the engine harness ground terminal (3) to the stud (2).
  13. Install the engine harness ground nut (1).

    Tighten:  Tighten the nut to 17 N.m (13 lb ft).

    14. Fig 6: View Of Negative Battery Cable Ground Terminal And Stud (RPOs L61/LE5)
    GM1656128Courtesy of GENERAL MOTORS CORP.
  14. If equipped with RPOs L61/LE5 with MN5 perform the following, install the negative battery cable ground terminal (2) to the stud (1).
  15. Install the engine harness ground terminal (3) to the stud (1).
  16. Install the engine harness ground nut (4).

    Tighten:  Tighten the nut to 17 N.m (13 lb ft).

  17. Lower the vehicle.
  18. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals