LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 651 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Negative Cable Replacement (Battery to Battery Tray) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Battery Connections
    GM1656237Courtesy of GENERAL MOTORS CORP.
  1. Install the negative battery cable (3). Ensure that the anti-rotation tab on the terminal (5) is correctly located.
    2. NOTE: Refer to Fastener Notice .
  2. Install the negative battery cable ground bolt (4).

    Tighten:  Tighten the bolt to 17 N.m (13 lb ft).

  3. Connect the body harness electrical connector (7) to the battery current sensor (6).
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals