Tail Lamp Replacement (Chevy/Pontiac Sedan)

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Tail Lamp Assembly

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Tail Lamp Assembly Replacement
1	Tail Lamp Nut (Qty: 2) NOTE: Refer to Fastener Notice . Tip: Remove from inside rear compartment. If only servicing the bulbs, turn the bulb/socket and pull out of the lamp assembly. This can be done from inside of the rear compartment, without removing the lamp from the vehicle. Tighten: 10 N.m (89 lb in)
2	Tail Lamp Bolt (Qty: 2) Tighten: 10 N.m (89 lb in)
3	Tail Lamp Tip: Pull the lamp from the pocket. Disconnect the electrical connector.