Tail Lamp Replacement (Chevy Export)

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Tail Lamp Assembly and/or Backup, Sidemarker, Stop, Turn Signal Bulb Replacement (Chevy Export)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Tail Lamp Assembly Replacement
1	Tail Lamp Bolt Tip: Remove the nut from inside the rear compartment. If only servicing the bulbs, turn the bulb/socket and pull out of the lamp assembly. This can be done from inside of the rear compartment, without removing the lamp from the vehicle.
2	Tail Lamp Nut NOTE: Refer to Fastener Notice . Tighten: 10 N.m (89 lb in)
3	Tail Lamp Nut Tighten: 10 N.m (89 lb in)
4	Tail Lamp Assembly Tip: Pull the lamp from the pocket. Disconnect the electrical connector.