LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 650 (Lighting Systems) >> Diagnostic Information and Procedures >> Instrument Panel Compartment Lamp Inoperative

Instrument Panel Compartment Lamp Inoperative

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Instrument Panel Compartment Lamp Inoperative

Step Action Yes No
Schematic Reference: Interior Lights Schematics 
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to DIAGNOSTIC SYSTEM CHECK - VEHICLE
2 Open the instrument panel (I/P) compartment.
Does the I/P compartment lamp illuminate?
Go to Testing for Intermittent Conditions and Poor Connections Go to Step 3 
3 Do the courtesy lamps operate properly? Go to Step 4  Go to Courtesy Lamps Inoperative 
4
  1. Disconnect the I/P compartment lamp switch.
  2. Probe the courtesy lamps supply voltage circuit of the I/P compartment lamp with a test lamp that is connected to a good ground.
Does the test lamp illuminate?
Go to Step 5  Go to Step 7 
5 Connect a test lamp between the courtesy lamps supply voltage circuit and the ground circuit of the I/P compartment lamp.
Does the test lamp illuminate?
Go to Step 6  Go to Step 8 
6 Inspect for poor connections at the harness connector of the I/P compartment lamp switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .
Did you find and correct the condition?
Go to Step 10  Go to Step 9 
7 Repair an open or high resistance in the courtesy lamps supply voltage circuit. Refer to Circuit Testing and Wiring Repairs .
Did you complete the repair?
Go to Step 10  -
8 Repair an open or high resistance in the ground circuit. Refer to Circuit Testing and Wiring Repairs .
Did you complete the repair?
Go to Step 10  -
9 Replace the I/P compartment lamp switch.
Did you complete the replacement?
Go to Step 10  -
10 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 3