LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 650 (Lighting Systems) >> Diagnostic Information and Procedures >> Headlamps Inoperative - Flash to Pass

Headlamps Inoperative - Flash to Pass

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Headlamps Inoperative - Flash to Pass

Step Action Yes No
Schematic Reference: Headlights/Daytime Running Lights (DRL) Schematics 
Connector End View Reference: Master Electrical Component List
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  DIAGNOSTIC SYSTEM CHECK - VEHICLE
2
  1. Turn the ignition switch to the ON position.
  2. Turn the headlamp switch to the HEAD position.
  3. Place the headlamp dimmer switch to the HIGH position.
  4. Verify that the high beam headlamps operate properly.
Do the high beams operate properly?		 Go to Step 3  Go to Headlamps Inoperative - High Beams 
3
  1. Disconnect the body control module (BCM) connector C2.
  2. Probe the flash-to-pass switch signal circuit of the BCM C2 connector with a test lamp that is connected to battery positive voltage.
  3. Pull and hold the Flash-to-Pass switch.
Does the test lamp illuminate?		 Go to Step 8  Go to Step 4 
4
  1. Disconnect the multifunction switch connector
  2. Probe the ground circuit of the multifunction switch with a test lamp that is connected to battery positive voltage.
Does the test lamp illuminate?		 Go to Step 6  Go to Step 5 
5 Repair an open or high resistance in the ground circuit of the multifunction switch. Refer to Circuit Testing and Wiring Repairs .
Did you complete the repair?		 Go to Step 9  -
6 Test for a poor connection, open or short to battery positive voltage in the flash to pass signal circuit. Refer to Circuit Testing and to Wiring Repairs .
Did you find and correct the condition?		 Go to Step 9  Go to Step 7 
7 Replace the multifunction switch. Refer to Turn Signal Multifunction Switch Replacement .
Did you complete the repair?		 Go to Step 9  -
8 Replace the BCM. Refer to Control Module References for replacement, setup, and programming.
Did you complete the repair?		 Go to Step 9  -
9
  1. Connect all connectors and components that were disconnected.
  2. Verify that the flash to pass system operates properly.
Does the flash to pass system operate properly?		 System OK Go to Step 2 
scientia non olet · About LEMON Manuals