Fog Lamp Indicator Inoperative

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Step	Action	Yes	No
Schematic Reference: Headlights/Daytime Running Lights (DRL) Schematics
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to DIAGNOSTIC SYSTEM CHECK - VEHICLE
2	Turn ON the ignition, with the engine OFF. Observe the fog lamp indicator on the instrument cluster. Does the indicator illuminate during the bulb check?	Go to Step 3	Go to Step 4
3	Place the headlamp switch in the HEADLAMP position. Place the fog lamp switch in the ON position. Does the indicator illuminate?	Go to Testing for Intermittent Conditions and Poor Connections	Go to Step 5
4	Inspect for poor connections at the harness connector of the instrument panel cluster (IPC). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition?	Go to Step 8	Go to Step 6
5	Inspect for poor connections at the harness connector of the body control module (BCM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition?	Go to Step 8	Go to Step 7
6	Replace the IPC. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement?	Go to Step 8	-
7	Replace the BCM. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement?	Go to Step 8	-
8	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2