LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 650 (Lighting Systems) >> Diagnostic Information and Procedures >> DTC B1480 >> Diagnostic Aids

Diagnostic Aids

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Perform a visual inspection for loose or poor connections at all related components. Refer to Testing for Intermittent Conditions and Poor Connections .

DTC B1480

Step Action Yes No
Schematic Reference: Interior Lights Schematics 
Connector End View Reference: Master Electrical Component List
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to DIAGNOSTIC SYSTEM CHECK - VEHICLE
2
  1. Install a scan tool.
  2. Turn ON the ignition.
Is DTC B1480 present?
Go to Step 3  Go to Testing for Intermittent Conditions and Poor Connections
3 Test the inadvertent power courtesy lamps supply voltage circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs .
Did you find and correct the condition?
Go to Step 5  Go to Step 4 
4 Replace the body control module (BCM). Refer to Control Module References for replacement, setup, and programming.
Did you complete the replacement?
Go to Step 5  -
5
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?
Go to Step 2  System OK