LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 646 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Rear Side Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
    2. Fig 1: View Of Rear Side Hood Seal
    GM872463Courtesy of GENERAL MOTORS CORP.
  2. Pull the rear side hood seal, located at the end of the plenum to hood seal, from the fender.
  3. Remove the seal from the vehicle.
  4. Clean any adhesive from the pinch-weld flange and hood hinge using 3M™ P/N 8984.
scientia non olet · About LEMON Manuals